Table of Contents
Advertisement
NetAtlas Enterprise 1.00 User's Guide
Figure 72 Configuration: System Configuration: Remote Management
The following table describes the labels in this screen.
Table 29 Configuration: System Configuration: Remote Management
LABEL
Services
Port
Apply
Secured Clients
Start
End
95
DESCRIPTION
This panel displays the services that you may use to remotely manage the
switch. Select the check box(es) to allow remote management using the
service(s).
Enter the number of the server port to use with the corresponding service.
Click Apply to save the changes back to the switch.
Select the check box(es) to enable the client set.
To allow a range of computers to use Telnet, FTP, HTTP, ICMP, SSH or
HTTPS services, enter the first IP address in the range here.The default
value for a start and end address is 0.0.0.0, which means you don't care
which host is trying to use a service (Telnet, FTP, HTTP, SNMP, ICMP, SSH
or HTTPS).If you enter an IP address in this field, the switch will check if the
client IP address matches the value here when a (Telnet, FTP, HTTP,
SNMP, ICMP, SSH or HTTPS) session is up. If it does not match, the
session is disconnected immediately.
To allow a range of computers to use Telnet, FTP, Web, SNMP or ICMP
services, enter the End IP address in the range here. To allow a single
computer to use Telnet, FTP, HTTP, SNMP, ICMP, SSH or HTTPS
services, enter the same IP address here as in the Start field.
Chapter 10 System Configuration
Advertisement
Table of Contents
