Table of Contents
Advertisement
NetAtlas Enterprise 1.00 User's Guide
Figure 115 EMS: Remove
2 Select ZyXEL NetAtlas Enterprise V1.00 and then click Change/Remove (or Add/
Remove depending on your version of Windows).
3 Click Yes when asked to confirm removal. The Uninstall Shield now runs.
4 Click OK when the uninstall has successfully completed. Restart the computer when
prompted.
16.4 Problems Finding a Device
Table 74 Problems Accessing the EMS
PROBLEM
In the SNMPc
Management
Console I cannot
find my device
159
CORRECTIVE ACTION
Check that you have compiled and added the MIB's correctly. See
page 32
for information on adding MIB's. Make sure these instructions are followed
exactly. The correct MIB's must be compiled in the correct order.
Check that you have enable auto-discovery; see
Check that the map object properties are correct for initial installation; see
1.7 on page
36. Make sure the IP address entered is the IP address of the switch
you want to manage via the EMS.
Make sure that you restarted your computer after you installed MySQL.
Check that the MySQL driver is correctly configured; see
Make sure that MySQL is running.
Make sure that the computer you have installed the EMS on, is connected to the
network where the switch is located.
Make sure your computer's Ethernet Card is working properly.
If the problem still persists, uninstall and re-install the EMS software.
Section 1.5 on
Section 1.6 on page
34.
Section
Section 1.8 on page
Chapter 16 Troubleshooting
39.
Advertisement
Table of Contents
