Status Indicator Led's - Fagor QC-PDS Hardware Manual

3.2

Status indicator LED's

i
i
For models QC-DR--F
Single QC-DR--F drives by FAGOR have four status indicator LEDs.
D8|D9 status leds
Configuration and error status leds.
Modes Meaning
OFF
ON
Blinking with t ON at 20 %
Blinking with t ON at 80 %
Left (led D8) / right (led D9) alternate blinking
Error
D8 D9
axis 2 configured
axis 2 not configured
axis 2 configured
axis 2 not configured
one blink per
sequence
Display the error codes on the QUERCUS CNC screen.
D10|D11 status leds
Status LEDs for Ethernet communication and SERCOS-III interface.
INFORMATION.
LEDs D10|D11 indicate the status of the transmission between two units
using a SERCOS-III connection. The information on these LEDs must
ONLY be interpreted on the unit connected in B10B.
Led Name Status
ON
D10 LINK
OFF
OFF
LIT FIXED
(not blinking)
D11 ACTIVITY
Blinking
Meaning
Initial state.
Equipment is not configured.
Equipment configured with
SERCOS-III communication and
without voltage in the DC BUS
Equipment configured with
axis 1 configured
SERCOS-III communication and
voltage + DC BUS is not enabled
E q u i p m e n t c o n f i g u r e d w i t h
axis 1 configured
SERCOS-III communication and
voltage + DC BUS is enabled.
No. of blinks =
Error status
Error group No.
Internal code error.
burst flickering
Miniboot error, non-DSP version
INFORMATION.
Meaning
Physical connection established
No connection
No activity
Establishing SERCOS-III communication
·active port·
2 Hz. Software update procedure or
inactive port.
4 Hz. SERCOS-III communication
established ·active port·
  Drives
3.
QC-PDS
HARDWARE
Ref.2003
· 119 ·