Attach The Console/Handlebar Assembly - Bowflex TreadClimber 1000 Assembly Manual

Step 8: Attach the Console/
Handlebar Assembly
Parts:
• TreadClimber Base and Treadle assembly from Step 7
®
• Console/Handlebar Assembly
Hardware:
• (6) 5/16" x 1" Button Head Screws
• (6) 5/16" Flat Washers SAE
Tools:
• 3/16" Hex Key (included)
Note: This step requires two people.
8-1 Lift and position the console/handlebar assembly above
the upright supports (See Figure 8-1).
8-2 Put the console/handlebar assembly cable through the
top of the right upright support (See Figure 8-2). Make
sure that the cable extends through the bottom of the right
upright.
8-3 Put both sides of the console/handle bar brackets into the
tops of the upright supports at the same time. Do not crimp
the cable.
8-4 Tighten the hardware with the 3/16" hex key (See Figure
8-3).
8-5 Connect the cable from the upright support to the cable on
the right side of the base upright bracket (See Figure 8-4).
8-6 One person will hold the Console/Handlebar assembly
while the second person removes the 5/16" x 1" button
head screw at the base of the support from each side.
8-7 Lower the upright on to the upright bracket base. Do not crimp
the cables. Drop the upright until flush with the base frame.
8-8 Attach the upright with (6) 5/16" x 1" button head screws
and (6) 5/16" flat washers SAE.
Note: Tighten the front (2) screws first (1 per upright) and then
the (4) side screws, two per outer side of upright (See
Figure 8-5).
12
Assembly Manual
Assembly
Figure 8-1
Figure 8-2
Figure 8-3
Figure 8-4
Figure 8-5