Attach The Uprights - Bowflex TreadClimber 1000 Assembly Manual

Step 6: Attach the Uprights
Parts:
• TreadClimber Base and Treadle assembly from Step 5
®
• (1) Left Upright Support & Hydraulic Cylinder
• (1) Right Upright Support & Hydraulic Cylinder
Hardware:
• (2) 5/16" x 1" Button Head Screws
Tools:
• 3/16" Hex Key
6-1 Install a 5/16" x 1" button head screw halfway into the
outside of the left and right lower upright brackets of the
base assembly (See Figure 6-1).
6-2 Put the left upright on the left upright bracket (see Figure
6-2) so that it rests on the button head screw (Figure 6-3).
The cylinder bracket will be at the top and face the rear of
the machine.
Note: Make sure the decal on the upright support faces outward from
the machine.
6-3 Repeat on the opposite side.
10
Assembly Manual
Assembly
Figure 6-1
Figure 6-2 - Right upright shown
Figure 6-3