Attach The Cosmetic Plugs; Attach The Hydraulic Cylinders - Bowflex TreadClimber 1000 Assembly Manual

Step 9: Attach the Cosmetic Plugs
Hardware:
• (4) Cosmetic Plugs
9-1 Insert the cosmetic plugs into the holes on the inside of the left
upright support (See Figure 9-1).
9-2 Repeat on opposite side.
Step 10: Attach the Hydraulic Cylinders
Parts:
• TreadClimber Base and Treadle assembly from Step 9
®
Hardware:
• (2) 5/16" x 1 1/2" Button Head Screws
• (2) 5/16" Acorn Nuts
• (2) 5/16" x 1" Button Head Screws (preassembled)
• (2) 5/16" Flat Washers (preassembled)
Tools:
• 3/16" Hex Key (included)
• 9/16" Open End Wrench (included)
Note: This step requires two people.
10-1 Attach the hydraulic cylinder to the upright bracket with (1) 5/16"x 1 1/2"
Button Head Screw and (1) 5/16" Acorn Nut (Figure 10-1).
Note: Make sure that the single white arrow, located on the Workout Level
Setting Dials at the top of the hydraulic cylinders, is pointing up and to
the rear of the machine.
10-2 Remove the pre-installed (1) 5/16" x 1" Button Head Screw and (1) 5/16"
Flat Washer from treadle. Lift treadle and slide the lower shock eyelet
onto the treadle stud.
10-3 Attach the hydraulic cylinder with the (1) 5/16" x 1" button head screw
and (1) 5/16" flat washer (Figure 10-2).
10-4 Tighten the hardware with the Hex Key and Open End Wrench.
Assembly
Figure 9-1
Figure 10-1
Figure 10-2
Assembly Manual
13