Cleaning The Water Intake Filter; Cleaning The Spray Arms - Smeg STU8642 Manual

Hide thumbs Also See for STU8642:

Table of Contents

6.2

Cleaning the water intake filter

Clean the water inlet filler at regular intervals. After closing the delivery

tap, unscrew the ring nut (ref. A fig. 6-01) on the water inlet pipe (using a

pair of pliers, if necessary) and delicately clean the filler, removing depos-

its or impurities.

Then firmly fix the pipe by tightening the ring nut (ref. A fig. 6-01) (use a

pair of pliers, if necessary).

6.3

The spray arms can be easily removed for periodic cleaning of the noz-

zles, to pre-vent possible clogging. Wash them under running water (at

room temperature) and carefully replace them in their seats, checking

that their rotary movement is in no way impeded; if this is not the case,

make sure they have been mounted properly.

Removing the spray arms

• To remove the upper spray arm (ref. A fig. 6-02), unscrew the locking

ring (ref. B fig. 6-02) by turning it clockwise. After cleaning, remount

the spray arm in its seat and tighten the locking ring by turning it anti-

clockwise.

• To remove the orbital spray arm assembly (ref. A fig. 6-03), take hold

of the lower arm (ref. B fig. 6-03) and pull the orbital unit upward (see

fig. 6-03).

After cleaning, remount the orbital spray arm in its seat and push it down

slightly until it clicks into place on the lower spray arm (see fig. 6-03). Then

remount the lower spray arm into its seat and push it down slightly until it

click into place (see fig. 6-03).

USER INSTRUCTIONS

Fig. 6-01

Table of Contents