Cleaning The Water Intake Filter; Cleaning The Spray Arms - Smeg STFABUCR1 Instruction Manual

Hide thumbs Also See for STFABUCR1:
Table of Contents

Advertisement

EN
EN
6.2
Clean the water inlet fil er at regular intervals. After closing the delivery tap, unscrew
the ring nut (ref. A fig. 6-01) on the water inlet pipe (using a pair of pliers, if neces-
sary) and delicately clean the fil er, removing deposits or impurities.
Then fi mly fix the pipe by tightening the ring nut (ref. A fig. 6-01) (use a pair of pliers,
if necessary).
6.3
The spray arms can be easily removed for periodic cleaning of the nozzles, to pre-
vent possible clogging. Wash them under running water (at room temperature) and
carefully replace them in their seats, checking that their rotary movement is in no
way impeded; if this is not the case, make sure they have been mounted properly.
Removing the spray arms
To remove the upper spray arm (ref. A fig. 6-02), unscrew the locking ring (ref. B
fig. 6-02) by turning it clockwise. After cleaning, remount the spray arm in its seat
and tighten the locking ring by turning it anti-clockwise.
To remove the orbital spray arm assembly (ref. A fig. 6-03), take hold of the lower
arm (ref. B fig. 6-03) and pull the orbital unit upward (see fig. 6-03).
After cleaning, remount the orbital spray arm in its seat and push it down slightly un-
til it clicks into place on the lower spray arm (see fig. 6-03). Then remount the lower
spray arm into its seat and push it down slightly until it click into place (see fig. 6-03).
34
30
USER INSTRUCTIONS
USER INSTRUCTION

Cleaning the water intake filter

Cleaning the spray arms

Fig. 6-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

StfabupbStfabublStfaburdStfabucr

Table of Contents