Table of Contents
Advertisement
2.2.3
End of program
The end of the program is signaled by a short beep. Additionally the indi-
cator light of the normal and strong programs (marked "end") flash.
PROGRAM IN PROGRESS INDICATOR LIGHT
(on some models only)
When a program is running, a flashing light is projected onto the floor un-
der the right-hand corner of the door. At the end of the program, the light
goes out to reduce sleep mode electricity consumption.
2.2.4
Interrupting a program
To interrupt the current program simply open the door of the dishwasher;
to restart the program, simply close the door again. The program restarts
from where it was interrupted.
2.2.5
Changing the current program
To change the current program, simply open the door of the dishwasher
and select the new program. Close the door to run the new program au-
tomatically.
2.2.6
Canceling the current program
• To cancel the current program, open the door and press and hold down the
program selection button (ref. 3 fig. 2-02) for a few seconds until the indica-
tor lights of the fourth and fifth programs turn on (ref. pr. 4, pr. 5 fig. 2-03).
• Close the door again.
• After about 1 minute, the dishwasher terminates the cycle and the in-
dicator lights of the fourth and fifth programs (ref. pr. 4, pr. 5 fig. 2-03)
start flashing.
symbols programs according to the models
USER INSTRUCTIONS
QuickTime
Auto
Auto
2
3
4
5
end
end
end
EN
12
11
10
9
8
½
Sanitized
QuickTime
FIG. 2-03
11
7
6
1
Advertisement
Table of Contents
Troubleshooting
