Smeg STU8642 Manual page 17

Auto
E1
FAULT
E2
end
E1
E6
Auto Auto
E3
end
E2
Auto Auto
E4
end
E3
Auto Auto
E7
E5
end
E4
Auto
Auto
E6
end
E5
Auto
Auto
E7
end
E8
E6
Auto Auto
E8
end
E7
Auto Auto
E9
E9
end
E8
Auto Auto
E11
E11
end
E9
Auto Auto
Light off
end
E11
Auto
Auto
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the fault.
• Alarms E1, E2, E3, E4, E8, E9 immediately terminate the current program.
• Alarms E5, E6 interrupt the current program and, after the problem has
been eliminated, resume the cycle.
• Alarm E7 is displayed at the end of the cycle which, however, is completed
given that it does not jeopardize the operation of the dishwasher.
• E11: Contact the after-sales service.
To "reset" an alarm:
• open or close the door, or switch the appliance on and back off again. At
this point, the dishwasher can be programmed again.
If the fault persists, contact the Authorized Technical Assistance
Service.
end
USER INSTRUCTIONS
Auto
end
Auto
Water pump-out malfunction
end
The appliance does not pump out the water or
does so incorrectly. Make sure the drain hose
Auto
end
is not kinked or crushed and that the siphon
and filters are not clogged.
end
If the problem persists, contact the technical
Auto
end
assistance service.
end
Turbine flow-regulator malfunction
(only for models fitted with this feature)
Auto
end
The appliance is unable to precisely measure
the quantity of incoming water. Interrupt the
end
current program and switch off the dishwash-
Auto
end
er. Switch it back on again, program a new
cycle and press start. If the problem persists,
end
contact the technical assistance service.
Auto
end
Alternate washing system malfunction
Interrupt the current program and switch
end
off the dishwasher. Switch it back on again,
Auto
end
program a new cycle and press start. If the
problem persists, contact the technical assis-
end
tance service.
Auto
end
Water intake system malfunction
end
Contact the technical assistance service.
Auto
end
end
Wash motor pump does not work
Auto
end
Light on
end
end
DESCRIPTION
E1
E2
E3
E4
E5
E6
E7
E8
E9
Light flashing
E11
EN
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto
end
Auto Tab. 4-01a
end
Auto
17