Stihl FS 160 Instruction Manual page 73

Mounting the handlebar
5
1
4
6
3
2
Place the handlebar (1) in the lower
N
clamp (2) so that distance A is
about 15 cm.
Fit the upper clamp (3) and tighten
N
the two screws (4) moderately.
Push the hex screw (5) with
N
washer (6) through the two clamps
as far as stop – hold all parts
together.
FS 160, FS 220, FS 280, FS 290
A
A
Place the assembly on the handle
N
support (7) with the hex screw at the
side nearest the engine.
Push the hex screw (5) into the
N
handle support as far as stop and
then screw it down – but do not
finally tighten yet.
Position the handlebar at a right
N
angle to the drive tube – check
distance A again.
Tighten down the screws firmly.
N
5
7
Mounting the control handle
4
3
1
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert screw and tighten it down
N
firmly.
Fitting the throttle cable retainers
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
English
6
5
6
71