Stihl FS 160 Instruction Manual page 72

English
FS 220, FS 280, FS 290 – Mounting
handle support and bike handle
Mounting the handle support
Remove the seven mounting
N
screws from the support (1) and
take away the front part of the
support.
70
1
Check that the nut (2) is in position
N
in the handle support.
Fit the drive tube in the rear half of
N
the handle support – mounting area
for perforated strip must face
engine.
Fit the perforated strip (3) and line
N
up the holes.
Fit the front half of the support.
N
Fit the seven mounting screws but
N
do not tighten them down yet.
2
3
A
1
Position the support so that the
N
distance (A) between it and the
clutch housing (4) is about 24 cm.
Now tighten down the seven
N
mounting screws on the support
firmly.
FS 160, FS 220, FS 280, FS 290
4