Stihl FS 160 Instruction Manual page 70

English
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
12
13
13
12
13
Push the throttle cable (12) into the
N
retainer (13).
Adjusting the throttle cable
On control handles with slide:
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
68
FS 220, FS 280, FS 290 – Mounting
bike handle with preassembled handle
support
Adjusting and securing the handlebar
2
1
3
Perforated strip on handle
N
support (3) faces operator.
Loosen the hex head screw (1).
N
Rotate the bike handle on the
N
support (3) a quarter turn
counterclockwise.
Swing the ends of the handlebar up.
N
Tighten down the hex head
N
screw (1) firmly.
Push the handlebar to the left until
N
distance (A) is about 15 cm.
Tighten down the screws (2) firmly.
N
A
Remove the seven mounting
N
screws from the support (3) and
take away the front part of the
support.
Position the drive tube in the rear
N
part of the support.
Refit the front part of the support.
N
Fit the seven mounting screws but
N
do not tighten them down yet.
FS 160, FS 220, FS 280, FS 290
3