Table of Contents
Advertisement
Using ALP and DS90UB95x Profile
13.3 Registers Tab - Address 0x00 Expanded
By double clicking on the Address bar
or a single click on
. Address 0x00 expanded reveals contents by bits. Any register address displayed can be
expanded.
Any RW Type register can be written into by writing the hex value into the "Value:" box,
the pointer into the individual register bit(s) box by a left mouse click to put a check mark (indicating a "1") or
unchecking to remove the check mark (indicating a "0"). Click the "Apply" button to write to the register, and
"refresh" to see the new value of the selected (highlighted) register.
The box toggles on every mouse click.
13.3.1 Port Specific Registers
13.3.2
Certain registers in the DS90UB95x-Q1 are port specific and have two copies, one for each FPD-Link RX port.
The "Select RX Port" drop-down menu controls which port's registers are read. If the "Write All RX Ports" box
is checked, both ports' registers will be written to. If it is not checked, only the port indicated by the drop-down
menu will be written to. These controls set the value of register 0x4C, which is used to set which port is being
read and which port(s) are being written to.
13.4 Saving and Loading Register Settings
Register settings can be saved and later loaded to the device using the "Save" and "Load" buttons. To save,
click on the "Save" button, select the file location, and name the file. If desired, comments may be recorded
22
DS90UB95x-Q1EVM Deserializer User's Guide
Figure 13-3. ALP Device ID Expanded
Copyright © 2021 Texas Instruments Incorporated
or putting
SNLU223B – AUGUST 2017 – REVISED APRIL 2021
Submit Document Feedback
www.ti.com
Advertisement
Table of Contents
