Typical Connection And Test Equipment; Termination Device; Typical Test Setup; Typical Test Setup For Evaluation - Texas Instruments DS90UB954-Q1EVM User Manual

Typical Connection and Test Equipment

5 Typical Connection and Test Equipment
The following is a list of typical test equipment that may be used to monitor the MIPI CSI-2 signals from
the DS90UB954-Q1:
1. Logic Analyzer
2. Any SCOPE with a bandwidth of at least 4 GHz for observing differential signals.
3. UNH-IOL MIPI D-PHY Reference Termination Board (RTB)
4. UNH-IOL MIPI D-PHY/CSI/DSI Probing Board
5. UNH-IOL CSIGUI Tool
6

Termination Device

A termination device is required to properly monitor and measure the transmission of the MIPI DPHY
signals. The termination device should support the change of signals as it switches between LP and HS
modes. This can be provided by either a CSI-2 receiver or a dedicated dynamic termination board. The
recommended termination board is the UNH-IOL MIPI D-PHY Reference Termination Board (RTB).
7

Typical Test Setup

Figure 7 illustrate the typical test setups used to measure and evaluate DS90UB954-Q1.
Figure 7 shows a typical test set up using a logic analyzer or oscilloscope.
12
DS90UB954-Q1EVM Quick Start
Figure 7. Typical Test Setup for Evaluation
Copyright © 2017, Texas Instruments Incorporated
www.ti.com
SNLU223 – August 2017
Submit Documentation Feedback