Srt Instrument Cluster Descriptions - Dodge CHALLENGER 2020 Owner's Manual

SRT I C
NSTRUMENT LUSTER
D
ESCRIPTIONS
1. Tachometer
Indicates the engine speed in revolutions

per minute (RPM x 1000).
2. Instrument Cluster Display
When the appropriate conditions exist, this

display shows the instrument cluster
display messages. Refer to "Instrument
Cluster Display" in "Getting To Know Your
Instrument Panel" for further information.
3. Speedometer
Indicates vehicle speed.

4. Fuel Gauge
The pointer shows the level of fuel in the

fuel tank when the Keyless Push Button
Ignition is in the ON/RUN position.
The fuel pump symbol points

to the side of the vehicle where
the fuel door is located.
Refer to "Refueling The Vehicle" in "Starting
And Operating" for further information.
5. Temperature Gauge
The temperature gauge shows engine

coolant temperature. Any reading within
the normal range indicates that the
engine cooling system is operating satis-
factorily.
The gauge pointer will likely indicate a

higher temperature when driving in hot
weather, up mountain grades, or when
towing a trailer. It should not be allowed
to exceed the upper limits of the normal
operating range.
WARNING!
A hot engine cooling system is dangerous.
You or others could be badly burned by steam
or boiling coolant. You may want to call an
authorized dealer for service if your vehicle
overheats.
GETTING TO KNOW YOUR INSTRUMENT PANEL
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the
temperature gauge reads greater than 230°F
(110°C) pull over and stop the vehicle. Idle
the vehicle with the air conditioner turned off
until the pointer drops back into the normal
range. If the pointer remains above 230°F
(110°C), turn the engine off immediately and
call an authorized dealer for service.
NOTE:
The hard telltales will illuminate for a bulb check
when the ignition is first cycled.
77
3