Ip Settings - Viessmann Vitoflex 300-UF Series Installation And Operating Instructions Manual

Vitoflex 300-UF Installation & Operating

IP Settings

Legend
A Entry field "IP address"
B Entry field "Subnet mask"
C Entry field "Gateway"
Tap the following keys:
1. "Menu"
2. "Special functions"
3. "IP settings"
The following screen opens.
By entering the correct IP settings, you can link the
controller into a network.
Displaying your own network settings
Most networks incorporate a DHCP server which
automatically assigns an IP address to appliances in the
network and enables them to communicate with each
other.
You can find out whether the computer has an IP
address and if so which one, with the "ipconfig" DOS
command:
1. On the computer, press the Windows and R key
combination.
2. In the entry field, enter "cmd".
3. Confirm with OK.
The command line window opens.
4. In the command line window, enter the command
"ipconfig".
5. Press Enter to confirm.
The computer's current IP address, subnet mask
and default gateway are displayed under "Ethernet
adapter Local Area connection".
6. Note down the IP address, subnet mask and default
gateway for subsequent configuration.
Configuring the controller network
Ensure that the following requirements are met:
Controller and computer are connected to the network.
Controller is switched on.
1. On the programming unit, tap on "IP settings".
2. Select an available IP address in the same network
segment to which the computer is connected.
3. Note: When entering the address, use the full stop on
the number keypad as separator. Enter the
available IP address in the "IP address field".
4. Enter the values you previously noted down under
"Subnet mask" and "Gateway".
The network is now configured. It is possible to
access the controller with a VNC viewer.
Accessing the controller via the network
1. Start your VNC viewer.
2. In the VNC viewer, enter the IP address of the controller.
3. Start the connection process.
The controller's screen contents are shown in the
VNC viewer. You can now operate the heating
system via the viewer.
Additional Settings
57