Table of Contents
Advertisement
Before beginning any service work turn
WARNING:
off the PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
Mower Mounting Hardware Installation
1. On the left side of discharge opening, insert 1/4-20x1.25"
carriage bolt (A, Figure 1) thru inside of mower deck and
secure with conical nut as shown (B).
B
Figure 1
Frame Hung Mowers
1. Remove existing hardware from outside of the front-right
wheel bracket (A, Figure 2).
2. Replace with 1.25" carriage bolt (B) spacer (C), .312" ID
x 1.25" OD. washer (D) and secure with flange locknut
(E) as shown.
A
B
C
Figure 2
A
D
E
Free Floating Mowers
1. From the inside of deck, near front of discharge opening
assemble 1.25" carriage bolt (A, Figure 3), .341" OD x
1.00" OD. washer (B), spacer (C), .341" OD x 1.25" OD.
washer (D) and secure with flange locknut (E) as shown.
A
Figure 3
5
Assembly
B
C
D
E
Advertisement
Table of Contents
