IBM Power System E950 User Manual page 79

Memory modules for the 9040-mr9
Hide thumbs Also See for Power System E950:
Table of Contents

Advertisement

Figure 47. Replacing a memory module
3. To insert the memory riser, complete the following steps:
a) Ensure the release latches (A) are fully open to a 90 degree angle as shown in the following figure.
b) Align the memory riser with the connector.
c) Press the memory riser firmly into the connector.
d) Rotate the release latches into the closed position, and press the release latches down to ensure
that the memory riser is fully seated into the connector.
Memory riser for the 9040-MR9 65

Advertisement

Table of Contents
loading

This manual is also suitable for:

9040-mr9

Table of Contents