IBM Power System E950 User Manual page 44

Memory modules for the 9040-mr9
Hide thumbs Also See for Power System E950:
Table of Contents

Advertisement

• Each memory riser card must have 8 DIMMs.
• Each system processor must have one memory riser card.
• Unused memory module connectors must have a memory module filler.
• Unused memory riser positions must have a memory riser filler.
• A memory riser card can have up to 16 DIMMs.
• Each system processor can have two memory riser cards.
• All memory modules must be of the same size and type on each memory riser.
• The memory module connector colors are black and white. The first eight memory modules must be
installed in the white-colored DIMM connectors.
• If the memory riser cards for the processors have different capacities, populate the largest memory
riser card with system processor CP0.
• Consider the following requirements when you add memory riser cards:
– After all of the first memory riser cards for the system processors are filled up, add a second memory
riser card to system processor CP0. The second memory riser card of each system processor can
have different memory module capacities from the memory module capacity of the first memory riser
card. It is recommended that the memory modules of the second memory riser card have the same
type and size as the first memory riser card.
– Add a second memory riser card to system processor CP1, then to system processor CP2, and finally
to system processor CP3.
Permanently removing memory modules from the 9040-MR9 system
Find information about permanently removing memory modules from the IBM Power System E950
(9040-MR9) server.
About this task
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in
the system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).
If your system is not managed by an HMC, complete the steps in the following procedures to permanently
remove a memory module from the system.
Note: Removing or replacing this feature is a customer task. You can complete this task yourself, or
contact a service provider to complete the task for you. You might be charged a fee by the service
provider for this service.
Preparing the 9040-MR9 system to permanently remove memory modules
To prepare a system to permanently remove memory modules, complete the steps in this procedure.
Before you begin
Record the plugging order of the memory module slots for the installation.
This information describes the rules for memory modules in the system.
• The system supports DDR4 memory modules of 8 GB, 16 GB, 32 GB, 64 GB, and 128 GB.
• The system has eight memory riser cards.
• Each memory riser card must have 8 DIMMs.
• Each system processor must have one memory riser card.
• Unused memory module connectors must have a memory module filler.
• Unused memory riser positions must have a memory riser filler.
30 Power Systems: Power Systems: Memory

Advertisement

Table of Contents
loading

This manual is also suitable for:

9040-mr9

Table of Contents