Table of Contents
Advertisement
Figure 34. Removing the service access cover
Installing a memory riser in the 9040-MR9 system
To install memory riser cards in a system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Use the slot information that you recorded to determine the slot location to place the memory riser.
3. For each memory riser that you are installing, remove a memory riser filler from that slot as shown in
Figure 35 on page 50.
Memory riser for the 9040-MR9 49
Advertisement
Table of Contents
