Yamaha RX-V4600 Owner's Manual page 89

5
Press SELECT k / n to exit from the
Zone 2/Zone 3 mode.
Notes
• The source in Zone 2 and the source available for recording are
always the same.
• "ZONE2" or "ZONE3" will appear in the display window only
when k is pressed, and "SYSTM" only when n is pressed.
■ Turning on this unit or setting it to the
standby mode
SYSTEM POWER and STANDBY work differently
depending on the selected mode that appears on the
display window.
• When normal, Zone 2 or Zone 3 mode is selected, you
can turn on the main unit, Zone 2 or Zone 3 or set them
to the standby mode individually.
• When System mode is selected, or when "2000" or
"2002" (see page 72) is selected as the amplifier library
(L;AMP) code, pressing SYSTEM POWER turns on
the main unit only. However, pressing STANDBY sets
everything (the main unit, Zone 2 and Zone 3) to the
standby mode simultaneously.
LCD display
* Name of component
Normal mode
"Zone2" or "2:name of
Zone 2 mode
component"
"Zone3" or "3:name of
Zone 3 mode
component"
"SYSTM"
System mode
*
"MAIN" appears for a few seconds when SYSTEM
POWER or STANDBY is pressed.
Note
To control Zone 2 or Zone 3 again when System mode is selected
and the main unit, Zone 2 and Zone 3 are in the standby mode,
press SYSTEM POWER to turn on the main unit, then repeat
steps 1 through 5 of the procedure in "To control Zone 2/Zone 3"
on pages 84 and 85.
■ Special considerations for DTS software
The DTS signal is a digital bitstream. If you attempt to
send the DTS signal to the second/third room you will
only hear digital noise (that may damage your speakers).
Thus, the following considerations and adjustments need
to be made when playing DTS encoded discs.
For DVDs encoded with DTS
Only 2 channel analog audio signals may be sent to the
second/third room.
Use the disc menu to set the DVD player's mixed
2-channel left and right audio outputs to the PCM or
Dolby Digital soundtrack.
For CDs encoded in DTS
To avoid unexpected noise, DO NOT USE the
Zone 2/Zone 3 feature with CDs encoded in DTS.
SYSTEM POWER/
STANDBY
Turns on the main
unit only or sets it to
the standby mode.
Turns on Zone 2 or
sets it to the standby
mode.
Turns on Zone 3 or
sets it to the standby
mode.
SYSTEM POWER:
turns on the main
unit only.
STANDBY:
sets everything
(the main unit,
Zone 2 and Zone 3)
to the standby mode
simultaneously.
ZONE 2/ZONE 3
85