Setting Manufacturer Codes - Yamaha RX-V450 Owner's Manual

Setting manufacturer codes

You can control other components by setting the
appropriate manufacturer codes. Codes can be set up for
each input area. For a complete list of available
manufacturer codes, refer to "LIST OF
MANUFACTURER CODES" at the end of this manual.
The following table shows the factory preset component
(Library: component category) and the manufacturer code
for each area.
Component
Input area category
(Library)
CD CD
MD/CD-R CD-R
*1
TUNER TUNER
DVD DVD
*2 –
DTV/CBL
V-AUX –
VCR –
*1
You have control only over this unit and other YAMAHA
tuners.
*2
You can only set TV manufacturer codes for the DTV/CBL
button. You must set TV manufacturer codes at the DTV/CBL
button.
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set other YAMAHA manufacturer code(s).
Manufacturer Code
YAMAHA 199
YAMAHA 499
YAMAHA fixed
YAMAHA 699
– –
– –
– –
1
Press and hold CODE SET. With CODE SET
depressed, press an input selector button to
select the component you want to set up.
CD MD/CD-R
DVD DTV/CBL
REC
DISC SKIP
FREQ/RDS
Note
You must press and hold CODE SET throughout this
procedure.
2
With CODE SET depressed, use the numeric
buttons to enter the three digit manufacturer
code for the component to be used.
Refer to "LIST OF MANUFACTURER CODES" at
the end of this manual.
To reset the code, enter the factory-set code for each
component shown in the previous table.
REC
DISC SKIP
FREQ/RDS
MODE PTY SEEK
TV VOL
TV MUTE TV INPUT
STEREO
1
MUSIC ENTERTAIN
5
q/DTS
NIGHT
9
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• You can only assign one manufacturer code to each input
selector button.
REMOTE CONTROL FEATURES
TUNER SLEEP
VCR V-AUX
MULTI CH IN
AUDIO
CODE SET
EON
AMP
MULTI CH IN
AUDIO
CODE SET
EON
AMP
START
VOLUME
TV CH
MUTE
HALL JAZZ ROCK
2 3 4
TV THTR MOVIE
6 7 8
EX/ES STRAIGHT
0 10
ENTER
55