Cooper Crouse-Hinds Pro AFP Series Instruction Manual page 7

Manufacturer
Fluke
Our recommended multimeter is the Fluke 287 with the Fluke I800 current clamp accessory.
Refer to the equipment manufacturer's manuals for the proper use, maintenance and calibration
(if necessary) of all meters.
Anti-seize (marine grade preferred, Henkel/Loctite P/N 34395 or 34026 or equal
(http://www.henkelna.com/adhesives/product-search-1554.htm?nodeid=8797882515457) with a
K factor of 0.18 for fully coating the frangible coupling threads. This will help facilitate removal
of sheared frangible couplings or fixtures for replacement/maintenance. Only use an anti-seize,
as other materials may wash away.
IMPORTANT
A calibrated torque wrench (micrometer adjustable solid audible/tactile "click" impulse when
torque value attained with an accuracy of +/- 4%) to fit a 9/16 or 14 mm socket for drive size of
the socket to tighten the fixture base plate 3/8-16 UNC hex bolts to 336 in-lbs -0, +0% [37.9 -0,
+10%] with an anti-seize that has a K factor of 0.18 applied to fully cover the bolt threads.
Torque wrenches: Sturtevant Richmont P/N 810748, range 100 to 600 in-lbs or equal, or
Sturtevant Richmont P/N 810782, range 10 to 50 Nm or equal. Certificate of calibration
included with suggested torque wrenches. Note, never loosen bolts with a torque wrench.
A calibrated adjustable torque screwdriver to torque the external ground screw to 6 in-lbs
[1.81Nm] minimum. Sturtevant Richmont P/N 810568 (comes with bits [hex, slotted, Torx,
Phillips, sq. recess, bit holder, socket adapter], case and certificate of calibration), range 2 to 36
in-lbs/0.2 to 4 Nm or equal. Note, never loosen screws with a torque screwdriver.
Needle nose pliers for installing the extremely small header jumper onto a spare Power Supply
J203 header when required or removing the flag type fast-on terminals from the power supply.
Xcelite P/N NN54-2 miniature pliers, fine needle nose, ESD-Safe or equal.
Instruction Manual
PRO AFP Series LED
Inset Runway Guard Light L-852G
Failure to apply anti-seize at installation will result in near
impossible to impossible removal of a frangible coupling from a
threaded hub over time.
Model Number
287
WARNING:
6
DOCUMENT 1331
REV. A