Master Control Section - Yamaha MG 6FX Owner's Manual

Master Control Section

D
5
6
1 ST Master Fader
Adjusts the signal level to the ST OUT jacks.
2 GROUP Faders (1-2, 3-4)
Adjust the signal level to the GROUP OUT 1 to 4 jacks.
C
B
7
A
0
4
9
3
8
2 1
Front & Rear Panels
3 TO ST Switch
If this switch is on ( ), the mixer sends the signals processed
2
by the GROUP faders ( ) onto the Stereo bus. The Group 1/3
signal go to Stereo L and the Group 2/4 signal go to Stereo R.
4 Master SEND
• AUX1 and AUX2 Controls
Adjust the level of the signal output to the AUX1 SEND and
AUX2 SEND jacks.
• Master EFFECT Control
Adjusts the level of the signal on the EFFECT bus. This is the
signal that is output through the EFFECT jack.
These Master SEND controls do not affect the level
NOTE
of the signal sent from the internal digital effector
onto the Master EFFECT bus.
5 RETURN (AUX1, AUX2, and ST Controls)
• AUX1 and AUX2 Controls
Adjust the level of the mixed L/R signal sent from the
RETURN jacks (L (MONO) and R) to the AUX1 and AUX2
buses.
• ST Control
Adjusts the level of the signal sent from the RETURN jacks
(L (MONO) and R) to the Stereo bus.
If you supply a signal to the RETURN L (MONO)
NOTE
jack only, the mixer outputs the identical signal to
both the L and R Stereo buses.
6 2TR IN Control
Adjusts the level of the signal sent from the 2TR IN jack to the
Stereo bus.
7 PHANTOM +48 V Switch
This switch toggles phantom power on and off. If you set the
switch on, the mixer supplies power to all channels that provide
MIC input jacks (CHs 1–8, 9/10, 11/12). Set this switch on
( ) when using one or more condenser microphones.
When this switch is on, the mixer supplies DC +48 V
NOTE
power to pins 2 and 3 of all XLR-type jacks.
• Be sure to leave this switch off (
not using phantom power. Humming or damage
may result if you connect to an unbalanced device
or to an ungrounded transformer while this switch
is on ( ). But note that the switch may be left on
( ) without problem when connecting to bal-
anced dynamic microphones.
• To avoid damage to speakers, be sure to turn off
amplifiers (or powered speakers) before turning this
switch on or off.
) when you are
MG16/6FX
21