Xm Satellite Radio - Yamaha DVX-700 Owner's Manual

TROUBLESHOOTING
Problem
The picture is not displayed on the TV
screen.
The picture is not displayed on the TV
screen correctly.
The message "HDMI ERROR" is
displayed or the picture is not
displayed on the HDMI TV screen.
Tuner (FM)
Problem
FM stereo reception is noisy.
There is distortion, and clear reception
cannot be obtained, even with a good
FM antenna.
The desired station cannot be tuned
into with the automatic tuning method.

XM Satellite Radio

If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the causes and follow the corresponding remedies.
Status message
CHECK XM TUNER
CHECK ANTENNA
68
En
Cause
The TV cables may be connected
improperly.
If the COMPONENT VIDEO
OUTPUT and HDMI connections are
used simultaneously, the
COMPONENT VIDEO OUTPUT
jacks may output progressive video
signal regardless of the Component Out
setting.
The Video Output settings may be
incorrect.
The Component Out setting is set to
Progressive, but the TV connected to
the COMPONENT VIDEO OUTPUT
may not support progressive scanning.
The TV connected to the HDMI
OUTPUT terminal may not support the
selected resolution.
The wrong HDMI resolution may be
selected or an HDMI error may have
occurred.
Cause
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away, or
if the antenna quality is poor.
There is multi-path interference.
The signal is too weak.
Cause
The XM Mini-Tuner is not installed in
the XM Mini-Tuner Home Dock or the
XM Mini-Tuner Home Dock is not
connected to this unit.
The XM antenna is not connected to
the XM Mini-Tuner Home Dock or the
XM antenna cable has become
damaged.
Remedy
Make sure all cables are connected
properly.
Disconnect the HDMI component, or
connect a TV that supports progressive
video to the COMPONENT VIDEO
OUTPUT jacks.
Check the Video Output settings and
correct as necessary.
Change the Component Out setting to
Interlace.
Change the HDMI Resolution setting
to a resolution supported by the HDMI
TV.
Check the HDMI Resolution setting
and correct as necessary.
Reset the HDMI settings.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to
eliminate multi-path interference.
Use a high-quality directional FM
antenna.
Use the manual tuning method.
Remedy
Confirm the XM Mini-Tuner is fully
seated in the dock and check that the
XM Mini-Tuner Home Dock cable is
connected to this unit.
Check that the XM antenna is securely
connected to the XM Mini-Tuner
Home Dock and check the antenna
cable for damage. Replace the XM
antenna if the cable is damaged.
See
page
17
18
38
38
38
38
65
See
page
18
--
46
--
--
46
See
page
50
50