Wave Start - Yamaha EX5 Owner's Manual

Music synthesizer / realtime control / extended synthesis / tone generator / realtime control / extended synthesis
Hide thumbs Also See for EX5:
Table of Contents

Advertisement

FwdNoLp:
Each time a key is played, the sample will play back one
time from the Start point to the End point.
RevNoLp:
Each time a key is played, the sample will play back in
reverse one time, from the End point to the Start point.
Fwd Lp
Keyon
Plays back repeatedly until you release the key.
Fwd No Lp
Keyon
Plays back one time.
Rev No Lp
Keyon
Plays back in reverse one time.
About the Unit of the Sample Playback Parameters
If you change the following sample playback
parameters using the Data Dial or [INC]/[DEC]
keys, it may take some time for you since the
parameter value is too large. In such cases, press
[F1]: KNx*(Knob x Unit) to change the unit to 10,
100, 1000 or 10000 and use the related knobs to
adjust the values. For example, use the unit of 1000
to roughly search the figure and use the unit of 10
or 1 to finely determine the position or length.
Top point
End point
Data End
End point
Data End
End point
Data End

Wave Start

Sets the Start point for the sample playback. As seen
in the next diagram, the Start point can be set to
remove unwanted noise that exists before that point
in the sample.
Noise
Record Start
Settings: Differs depending on the sample length
Loop Top
Sets the Top point of the loop playback (the point
where the loop begins) within the range of the entire
sample. For example, when setting a loop for the
sustained sound of a violin, the Top and End point is
usually set after the attack portion of the sound. In
this way, the sample playback begins from the attack
portion which determines the characteristics of the
violin, and repeats basically the same sustained
portion of the sound. For the sounds which don't
have distinctive attack portion, you can leave this
parameter the same as the Start point.
Keyon
Settings: Differs depending on the sample length
Loop Length
Displays and sets the length from the Top point to
the End point. As this value moves, the End point
value will increase or decrease accordingly.
Settings: Differs depending on the sample length
180
Necessary portion
Start Point
Loop playback
Top point
End point
Keyoff

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex5rEx7

Table of Contents