Assigning A Battery Module Sitop Ups1100 To The Basic Device Sitop Ups1600 - Siemens SITOP UPS1600 Manual

Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
6. Select the PROFINET-interface.
7. Under "Ethernet addresses" in the inspector window enter the IP address of the
SITOP UPS1600, which was already assigned in theTIA Portal.
You have assigned a controller to the SITOP UPS1600.
3.3.6 Assigning a battery module SITOP UPS1100 to the basic device SITOP
UPS1600
The basic functions of the uninterruptible power supply are available with all of the battery
modules that are compatible with the SITOP UPS1600. The SITOP UPS100 5 Ah LiFePo
battery is first supported by the UPS1600 with SW version V2.1.
Additional functions are available with the SITOP UPS1100 battery module:
● Automatic detection of the battery module rated values
● Automatic management of up to six battery modules
● Temperature-controlled charging
● Battery fast test
● Diagnostics using the SITOP UPS Manager and the web server
Using an example, in the following steps, it is shown how the SITOP UPS1600 is assigned a
SITOP UPS1100 battery module.
Note
Only SITOP UPS1100 battery modules of the same type can be inserted into the slots of a
SITOP UPS1600.
The number of battery modules that can be configured is limited to six. The description is
only applicable to devices that were linked to via the HSP.
Preconditions
● STEP 7 in the TIA Portal has been opened and a project has been created.
● A SITOP UPS1600 has been integrated in the project.
48
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76