Sitop Ups1100 - Siemens SITOP UPS1600 Manual

Mounting/removing

5.2 SITOP UPS1100

5.2 SITOP UPS1100
Mounting the device in a housing or a control cabinet
The SITOP UPS1100 battery modules are built-in units. They must be mounted in a
housing or control cabinet where only qualified personnel have access.
All devices are suitable for direct wall mounting.
Devices 6EP4131-0GB00-0AY0 (1.2 Ah), 6EP4132-0GB00-0AY0 (2.5 Ah), 6EP4133-
0GB00-0AY0 (3.2 Ah) and 6EP4133-0JB00-0AY0 (5 Ah) can also be snapped onto a
standard mounting rail TH35×15 (EN 60715), and device 6EP4131-0GB00-0AY0 (1.2 Ah)
also onto a standard mounting rail TH35×7.5 (EN 60715).
The lower part of the control cabinet or the coolest location in the control cabinet should be
chosen as mounting location.
Mounting
See Chapter Dimensions and weight for the holes for wall mounting SITOP UPS1100
(Page 36).
To mount the device on a standard mounting rail, place it with the standard mounting rail
guide at the upper edge of the standard mounting rail and snap it in downwards. If this is too
difficult, push the device downwards while pressing on the rail as described for "Removal".
Note
The fuses should be inserted in the fuse holder only when commissioning the device
(charged batteries).
Removal
To remove the device, pull it forcibly downwards while removing it from the lower edge of the
standard mounting rail (see Image 5-5 Removal (example 6EP4133-0GB00-0AY0 (3,2 Ah))
(Page 143)). Then you can remove the device from the upper edge of the standard mounting
rail.
142
WARNING
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76