Deleting The User Code Record - Ricoh AP206 Operating Instructions Manual

Using the Operation Panel
E
Press { { { { T T T T } } } } or { { { { U U U U } } } } to select "On" or "Off", and then press { { { { #Enter} } } } .
<Log Protect>
Off
This registers the setting and returns to the "Maintenance" menu.
F
Press { { { { On Line} } } } .
The "Ready" message appears on the panel display.

Deleting the User Code Record

This procedure describes how to clear the User Code record.
Note
❒ If "Log Protect" is set to "On", you can not delete the User Code record. Select
"Off" in "Log Protect", and then follow the procedure below. ⇒ P.105 "Protect-
5
ing the User Code Record"
A
Check if the On Line indicator stays on. If not, press { { { { On Line} } } } .
B
Press { { { { Menu} } } } .
The following message appears on the panel display.
<Menu>
IPDL-C Menu
C
Press { { { { T T T T } } } } or { { { { U U U U } } } } to display "Maintenance", and then press { { { { #Enter} } } } .
<Menu>
Maintenance
The following message appears on the panel display.
<Maintenance>
1.Toner Level l
106
j
l
Power On Line Data In
Reset
Error
Menu Escape
Media Enter
ZDHS031E
j
l
j
l
j