Table of Contents
Advertisement
Paper and Other Media
• The standard tray or the Paper Cassette Type204 can hold up to 50 OHP
transparency sheets.
Note
❒ The number of sheets that can be loaded may vary depending on the pa-
per thickness and paper type.
• Make sure that the stack of paper is not higher than the OHP FILM upper
limit mark (T) inside the tray.
• In auto duplex printing, do not use OHP transparencies or they may stick
to the fusing unit and cause a misfeed.
3
• When printing on OHP transparencies, it may take 1 to 2 minutes before
printing starts in order to keep the printer in an appropriate condition.
❖ ❖ ❖ ❖ Envelopes
• When printing on envelopes, use the standard tray or the Paper Cassette
Type204 (option).
• You can select the sizes for the envelopes using the operation panel.
⇒ P.79 "Using the Operation Panel"
• Recommended types of envelopes are as follows:
• Com#10 Env
• DL Env
• Do not stack envelopes over the limit mark.
• Confirm that print side is facing up.
• Confirm that there is no air in the envelopes before loading.
• To get better print quality, it is recommended that you set the right, left,
top, and bottom print margins, to at least 20 mm (0.8") each.
• Do not print on both sides of envelopes.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten the leading edges (sides being fed into
the printer) of them by running a pencil or ruler across them.
• Some kinds of envelopes might cause misfeeds, wrinkles or poor printing.
• The print quality on envelopes may be uneven as different parts of an en-
velope have different thickness. Print one or two envelopes to check the
print quality.
• Avoid using the non-supported envelopes listed on P.27 "Paper not sup-
ported by this printer".
• Auto duplex printing onto envelopes is not available.
26
Advertisement
Table of Contents
