Network Setup; Introduction; Supported Operating Systems; Configuring Tcp/Ip - Xerox Printer fwww User Manual

4

Network setup

This chapter gives you step-by-step instructions for setting up your
machine for network connections.
This chapter includes:
•

Introduction

•

Supported operating systems

•

Configuring TCP/IP

• Setting Ethernet speed
• Restoring the network configuration
• Printing a network configuration page
Introduction
Once you have connected your machine to a network with an RJ-45
Ethernet cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following two methods:
Via the control panel
You can set up the following basic network parameters through the
machine's control panel:
• Configure TCP/IP
• Configure EtherTalk
Supported operating systems
The following table shows the network environments supported by the
machine:
Item
Network interface
Network operating
system
Network protocols
Dynamic addressing
server
• TCP/IP: Transmission Control Protocol/Internet Protocol
• IPP: Internet Printing Protocol
• SNMP: Simple Network Management Protocol
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Configuring TCP/IP
Your machine can be set up with a variety of TCP/IP network information,
such as an IP address, a subnet mask, a gateway, and DNS addresses.
There are several ways in which your machine can be assigned a TCP/
IP address, depending on your network.
• Static addressing: A TCP/IP address is assigned manually by the
system administrator.
• Dynamic addressing via BOOTP/DHCP: A TCP/IP address is
assigned automatically by the server.
Note
• Before configuring TCP/IP, you need to set the network
protocol to TCP/IP.
Static addressing
To enter a TCP/IP address from your machine's control panel, take the
following steps:
Press Menu until Network appears on the bottom line of the
1
display and press Enter.
Press Enter when TCP/IP appears.
2
Press the Scroll buttons until Static appears and press Enter.
3
Press Enter when IP Address appears.
4
4.1
<Network setup>
Requirements
• Ethernet 10/100 Base-TX
• Windows 98/Me/2000/XP
• Various Linux OS
• Macintosh OS 10.3 ~ 10.4
• TCP/IP on Windows
• IPP, SNMP
• DHCP, BOOTP