2-1-2
Connecting power cord
1
2
2-1-3
Setting up interface cable
1
2
3
16 • Chapter 2
If you have purchased any optional hardware, make sure you have
finished installing it before you come to this section.
Make sure the power switch is in the OFF [O] position.
Connect one end of the power cord to the socket at the rear of
the printer, then plug the other end of the power cord into a
grounded power outlet.
Appendix B Pin Configuration, &
1-4-4 Interface Cable
Switch off the power of both printer and computer.
Plug one end of the cable into the parallel connector on the
printer, and the other into the corresponding connector on your
computer.
Fasten the bail clips on the connector.