Table of Contents
Advertisement
Printer Status
Lower resolution
If the Auto-continue is off or the 15
used (continues)
seconds time-out value has not expired,
the printer will suspend all jobs until the
control panel button is pressed.
Job aborted
Indicates the printer has canceled the
received job in an unexpected situation,
such as, expired Wait time-out value in
non-volatile RAM or the print manager of
host PC cancels jobs in process.
If the Auto-continue is checked and the
15 seconds time-out value has expired,
the printer continues the print job.
If the Auto-continue is off or the 15
seconds time-out value has not expired,
the printer will suspend all jobs until the
control panel button is pressed.
Pause/Off-line
Indicates the printing is paused, or the
printer is off-line.
Hardware
Indicates hardware malfunction is
malfunction
detected. There are two categories of
hardware malfunction:
Controller fatal errors - detected by the
Engine fatal errors - detected at power-up
•
60
Chapter 4
Definition/Cause
diagnostic program at power-
up.
or during the use of the printer.
Action
A press of the control panel
button takes the printer on-line
again.
Turn off the printer and switch
on the power again. If the
printer still indicates Hardware
Malfunction, you should
contact your dealer or service
center.
In this status, you can know
which error has occurred by
holding down the control panel
button. (If the button is up,
Hardware Malfunction status
resumes.)
Table next page
Advertisement
Table of Contents
