Xerox DocuColor 2060 Operator's Manual page 293

2 06 0 /2 04 5
D O C U C O L O R
5
Reposition green handle 4a.
6
The Fuser area is on the right hand side of the Paper Transport. Lift handle 4c on
the right hand side and lay the Inverter Transport back.
7
Lift handle 4d and clear all jammed paper. Rotate knob 4e counterclockwise to
clear any immovable paper.
NOTE: Occasionally a sheet of paper wraps around the heat roll. (The heat roll
is visible when handle 4d is up.) DO NOT attempt to remove this sheet of paper
because the stripper fingers may be damaged if you attempt this procedure. Call
your Xerox service representative to remove this piece of paper.
8
Reposition green handle 4d and close the Inverter Transport 4c. Ensure the
magnets are in place front and back.
9
Slowly push in the Paper Transport until it stops. Ensure that the green handle is
seated properly.
10
Close the Right and Left Front Doors.
11
Follow the instructions on the Touch Screen to restart your print job.
O P E R A T O R M A N U A L
P S
R O B L E M O L V I N G
6–27