Xerox DocuColor 2060 Operator's Manual page 170

S
C A N N E R
4–60
3
Touch the document type for the area (Text, Photo, or Map) to be defined.
4
Use the up and down arrows to enter the size of the area for the starting points,
X1 and Y1, and the ending points, X2 and Y2. Measure the area to be defined
using a ruler with millimeters.
Measure from the registration edges of the document to obtain the X and Y
values.
5
Press the Enter Coordinates button.
6
Touch Next Area to define any additional areas with the same document type
(up to four areas). Press the Enter Coordinates button after each set of
coordinates is selected.
7
Repeat steps 3 through 6 until all areas are input.
8
Press the Save button.
9
If you need to change the type of document for another area, touch the document
type for the area (Text, Photo, or Map) to be defined.
10
Continue selecting job options for your job.
11
When you are finished selecting options, press the Start button.
2 0 60 /2 0 45
D O C U C O L O R O P E R A T O R M A N U A L