Table of Contents
Advertisement
System Guide
PCI Channel Interface PWB Trace Capture Procedure
Perform a Trace
Common Controller
2. The user could pause the printer (the green button on the
DocuSP GUI) until a large number of pages in the job have
been RIPped. If the user then resumes the printer at the
right time (some time before the whole job is RIPped), the
print engine will print all of the queued pages and the
controller will simultaneously finish ripping the remainder of
the job. To do this successfully, the user will need to watch
and compute the rate that DocuSP is ripping at. If you know
how many pages are in the job, then knowing that the printer
will generate paper at 60 ppm, you can compute how far from
the end of the job to release the printer so that RIP and print
finish at the same time.
Load the PCI Channel Interface PWB Trace command when
software is installed and the PCI Channel Interface PWB is
detected. This procedure is usually performed at the request of
Software Engineering or as part of a SPAR package.
To start the trace, perform the following:
1. Login as Administrator.
2. Select [System - Online Manager].
3. Select:
•
Channel Gateway - Enable
•
Input Device - Online
•
Input Control - Start
4. Submit a job from the host.
5. After the job is completely received by the Controller, select
Input Control - End.
6. Open a Terminal window.
7. Type cd /opt/XRXnps/XRXgrpset/bin and press <Enter>.
8. Type ./dspTrc > FileName.txt and press <Enter>.
9. Type ls -l and press <Enter> to see the new file and the file
size.
Hints and Tips
10-7
Advertisement
Table of Contents
