3
Hold the memory SIMM with the connection points
pointing toward the connector and position the notch as
shown.
4
Insert the memory SIMM all the way into the connector
at a 45° angle, and rotate it down until it snaps into place.
You can hear the memory option click into place.
5
Verify that both metal clips on the connector are fastened,
and that the two pins on each end of the connector are
pushed through the holes on the memory option.
6
Continue with the section "Closing the System Board from
the Front" on the next page.
Printer Memory
Appendix C: Printer Options
C-7