Touch Pilot Control: Detailed Menu Structure; Main Menu - Carrier Touch Pilot Manual

6 - TOUCH PILOT CONTROL: DETAILED MENU STRUCTURE

6.1 - Main menu

Icon Displayed text*
General Parameters
Temperatures
Pressures
Inputs Status
Outputs Status
Pump Status
Run Times
Modes
Setpoint Table
Configuration Menu
Trendings
* Depends on the selected language (English by default).
** The Trendings menu is displayed in form of a graph. For more information about Trendings, see section 7.18.
CAUTION: Since specific units may not include additional features, some tables may contain parameters that cannot be
configured for a given unit.
General Parameters Menu – GENUNIT
No. Name
1 CTRL_TYP
2 STATUS
3 CHIL_S_S
4 CHIL_OCC
5 min_left
6 HEATCOOL
7 HC_SEL
8
9 SP_SEL
10
14
Status Unit
0 to 2 -
- -
dsable/enable -
no/yes -
- min
Heat/Cool -
0 to 2 -
0 to 2 -
Description
General parameters
Temperatures
Pressures
Inputs status
Outputs status
Pump status
Run times
Modes
Setpoint
Configuration menu
(see also section 6.2)
Trendings **
Displayed text*
Local=0 Net.=1 Remote=2
Run Status
Net.: Cmd Start/Stop
Net.: Cmd Occupied
Minutes Left for Start
Heat/Cool status
Heat/Cool Select
0=Cool. 1=Heat. 2=Auto
Setpoint Select
0=Auto. 1=Spt1. 2=Spt2
Associated table
GENUNIT
TEMP
PRESSURE
INPUTS
OUTPUTS
PUMPSTAT
RUNTIME
MODES
SETPOINT
CONFIG
TRENDING
Description
Operating mode:
0 = Local
1 = Network
2 = Remote
Off, Running, Stopping, Delay, Trip out, Ready,
Override, etc.
Unit start/stop via Network: When the unit is in
Network mode, start/stop command can be forced
Unit time schedule via Network: When the unit is in
Network mode, the forced value can be used instead
of the real occupancy state
Minutes before the unit start-up
Heating/cooling status: Heat/Cool
Heating/cooling selection:
0 = Cooling mode
1 = Heating mode
2 = Auto mode (Not applicable to this unit!)
Setpoint selection
0 = Auto (schedule control)
1 = Setpoint 1 (active during occupied period)
2 = Setpoint 2 (active during unoccupied period)