Faults - Windsor Saber Blade 12 Owner's Manual

Maintenance schedule
After the work
Warning
Risk of damage. Do not wash down the
appliance with water and do not use ag-
gressive detergents.
Empty the recovery tank.
Clean the seals between the recov-
ery tank and the appliance.
Empty the solution tank.
Rinse the appliance: Fill the solution
tank with water (without detergent)
and let the appliance run for one
minute with the brush water supply
turned on.
Empty the solution tank.
Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
Clean the squeegee, check for wear
and replace if required (see "Mainte-
nance tasks").
Check the brush for wear and re-
place if required (see "Maintenance
tasks").
Yearly
Have the prescribed safety inspec-
tion carried out by an electrician.
Maintenance Works
Replace the squeegee.
Note
The squeegee is attached to the appli-
ance with snaps and can simply be
pulled off.
Move the squeegee lift pedal to posi-
tion „suction off" (Fig. 3 - position "1/
ON", see inside front cover).
Remove the solution tank from the
appliance.
Remove the recovery tank.
10
English
Lay the device down on the back-
side.
Pull off the squeegee downwards.
Insert the new squeegee and lock
them into place.
Replacing the brush
Remove the solution tank from the
appliance.
Remove the recovery tank.
Lay the device down on the back-
side.
Press the release button for the
brush and swivel the brush toward
the bottom and pull it off the driver.
Place the new brush on the driver
and lock into place on the opposite
side.
Frost protection
In case of danger of frost:
Empty the solution and recovery
tank.
Store the appliance in a frost-pro-
tected room.

Faults

Danger
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
Warning
Risk of damage to the appliance on ac-
count of water leakage. Empty the
waste water reservoir and the fresh wa-
ter reservoir prior to performing mainte-
nance on the appliance.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.