Siemens SIMATIC ET 200SP Manual page 49

Errors/accuracies
Linearity error (in relation to input range), (+/-)
Temperature coefficient range
Temperature coefficient zero point
Isochronous mode
Isochronous mode (application synchronized up to
terminal)
Filter and processing times (TWE), min.
Bus cycle time (TDP), min.
Interrupts/diagnostics/status information
Interrupts
● Diagnostics interrupt
● Limit alarm
Diagnostic messages
● Wire break/short circuit
● Overflow / underflow
Diagnostics LED
● Monitoring of the power supply (PWRLED)
● Channel status display
● For channel diagnostics
● For module diagnostics
Electrical isolation
Channels
● Between the channels
● Between the channels and the backplane bus
● Between the channels and the supply voltage
of the electronics
Analog input module AI 2xSG 4-/6-wire HS (7MH4134-6LB00-0DA0)
Manual, 09/2018, A5E41867508A-AB
0.025 % v. E.
≤ ± 6 ppm/K v. E.
≤ ± 0.25 μV/K
Yes
80 μs
125 μs
Yes
Yes; two high and two low limits with hysteresis
Yes; channel-by-channel
Yes
Yes; green PWR LED
Yes; green LED
Yes, red LED
Yes; green/red DIAG LED
No
Yes
Yes
Technical specifications
47