Siemens SINUMERIK 840D Description Of Functions page 343

11.03
6.2 Alarms from SIMODRIVE 611 digital
Alarms that may occur in connection with SINUMERIK Safety Integrated are
listed below.
300500
Axis %1, drive %2 system error, error codes %3, %
Parameter %1 = NC axis number
%2 = drive number
%3 = error code 1
%4 = error code 2
Explanation The drive has signaled a system error.
Safety Integrated:
Interrogation: In the corresponding clock cycle.
For FD: Regenerative stop (corresponds to STOP B)
For MSD: Pulse and controller inhibit (corresponds to STOP A)
The error occurs if the computation time of the drive processor is not sufficient
for the cycle indicated in the supplementary information.
Error No.: 03, Supplementary information: 40, monitoring clock cycle for
SINUMERIK Safety Integrated too low.
Response Mode group not ready
Channel not ready
NC stop for alarm
NC start inhibit in this channel
NC switches into the tracking mode
Alarm display
Interface signals are set
Remedy Increase the relevant clock cycle or subordinate clock cycle (e.g. current-
control, speed-control or position-control clock cycle) or deselect any functions
that are not required.
Program continuation Power-down the control and power-up again.
300743
Axis %1 drive %2 function not supported on this 611D controller
module
Parameter %1 = NC axis number
%2 = drive number
Explanation The 611D Performance control module is required for SINUMERIK Safety
Integrated. If this hardware has not been installed, this alarm is triggered.
This alarm is also triggered if the motors 1PH2/4/6 are connected but neither a
611D Performance control module nor 611D Standard 2 control module is
available.
Interrogation: When the control is running-up.
Response Mode group not ready
Channel not ready
NC start inhibit in this channel
NC stop for alarm
Alarm display
Interface signals are set
Remedy Replace the 611 digital control module.
Program continuation Power-down the control and power-up again.
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
6.2 Alarms from SIMODRIVE 611 digital
6 Alarms
6-343