Siemens SINUMERIK 840D Description Of Functions page 213

11.03
10388 $MN_PROFISAFE_IN_ASSIGN
MD number Assignment between external SPL interface $A_INSE and PROFIsafe input
module
Default: 0
Change becomes effective after RESTART
Data type: DWORD
Meaning The three lower positions indicate the least significant $A_INSE variables to be supplied.
The three upper positions indicate the most significant $A_INSE variables to be supplied.
Example:
PROFISAFE_IN_ASSIGN[0] = 4001:
The system variables $A_INSE[1...4] are supplied with the state of the input terminals of
the PROFIsafe module defined in MD PROFISAFE_IN_ADDRESS[0].
Special cases, errors
Corresponds with ...
10389 $MN_PROFISAFE_OUT_ASSIGN
MD number Assignment between external SPL interface $A_INSE and PROFIsafe output
module
Default: 0
Change becomes effective after RESTART
Data type: DWORD
Meaning The three lower positions indicate the least significant $A_OUTSE variables to be
supplied. The three upper positions indicate the most significant $A_OUTSE variables to
be supplied.
Example:
PROFISAFE_IN_ASSIGN[0] = 4001:
The system variables $A_OUTSE[1...4] are supplied at the output terminals of the
PROFIsafe module defined in MD PROFISAFE_OUT_ADDRESS[0].
Special cases, errors
Corresponds with ...
The following machine data
$MN_INFO_PROFISAFE_CYCLE_TIME
$MN_PROFISAFE_MASTER_ADDRESS
$MN_PROFISAFE_IN_ADDRESS
$MN_PROFISAFE_OUT_ADDRESS
$MN_PROFISAFE_IN_ASSIGN
$MN_PROFISAFE_OUT_ASSIGN
are included in the axial checksum machine data
$MA_SAFE_ACT_CHECKSUM. This means that, they are protected against
modification. Changes can only be confirmed and activated by pressing
"Confirm SI data" softkey.
Changes to the machine data and resulting axial checksums are displayed via
Alarm 27032, "Axis %1 Checksum error for safe monitoring. Acknowledgement
and acceptance test necessary!".
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Min. input value: 0
Protection level (R/W) 7/2
Applies from SW 6.3
Min. input value: 0
Protection level (R/W) 7/2
Applies from SW 6.3
4 Data Descriptions
4.1 Machine data
Max. input value: 64064
Unit: -
Max. input value: 64064
Unit: -
840D
840D
4-213