Eaton 9SX Series Manual page 75

 Mode 1-3(single source)
1. Input:
connect mian-ground cable (PE) to chassis first;
short 'AC input terminal N/N' with 'busbar #1', then connect AC cable(N);
short 'AC input terminal mL1/bL1/mL2/mL3' with 'busbar #8', then connect AC
cable(L);
2. Output:
connect ground cable (PE) to chassis first;
short '
AC segment
connect '
AC segment
3. Connect to UPS:
Remove all the busbar of the UPS, then connect the UPS to MBP with '
MBP accessory
UPS1' in
Note:
In this mode with UPS is working in Bypass mode, UPS's L2/L3 is power-off, MBP's
L2/L3 of AC segment 1/ segment 2 and Load 2 with IEC output sockets
(Programmable) are all power-off as well.
terminal N/N' with 'buabar #1', then connect AC cable(N);
terminal L1/L2/L3' to AC cable(L1/L2/L3).
.
Cable to
70