KYMCO XCITING S 400 Manual page 290

7. CVT Transmission > CVT Removal XCITING 400i
Remove the collar, snap ring, and bearing from the right face of the
driven pulley.
Clean the right face with a high flash point solvent and compressed air.
NOTE: Always wear safety glasses when using compressed air and
never point it directly at yourself or anyone else.
Drive in the new baring so the sealed side face out towards the
clutch. Install the snap ring into the groove. Install the collar and
drive in the new needle bearing so that its markings face out.
Drive in the bearings with a suitable driver with the same outside
diameter as the bearing.
4‐27