KYMCO XCITING S 400 Manual page 194

5. Cooling System
XCITING S 400
5.Cooling System
This chapter covers the location and servicing of the cooling system components
for the KYMCO XCITING S 400 model.
General Instructions ..................................................................... 5-1
Troubleshooting ........................................................................... 5-2
Coolant .......................................................................................... 5-3
Radiator ......................................................................................... 5-11
Water Temperature Sensor (WTS) ............................................... 5-16
GENERAL INSTRUCTIONS
• The water pump must be serviced after removing the engine. Other cooling
system service can be done with the engine installed in the frame.
• The engine must be cool before servicing the cooling system. When the coolant
temperature is over 100℃, never remove the radiator cap to release the pressure
because the boiling coolant may cause danger.
• Avoid spilling coolant on painted surfaces because the coolant will corrode the
painted surfaces. Wash off any spilled coolant with fresh water as soon as
possible.
• After servicing the system, check for leaks with a cooling system tester.
5-1