Chapter 4: Camera Installation
4.1 Power
DISCLAIMER:
The exact components of your system, images and quantities may vary depending on your model
number. While these may vary, this manual will address the setup and initial configuration of your NVR and cameras.
Locate an included 100 foot Ethernet cable.
1
Insert one end of the Ethernet cable into the camera's power cable.
2
Insert the other end of the Ethernet cable into an open Ethernet port on the back of the NVR.
3
Repeat for each camera, noting the channel number each camera is plugged into.
4
Make sure all cameras are working prior to mounting by connecting them as described in the
section above. Once all cameras are confirmed to be fully operational, you can run the cables and
mount the cameras at their final locations.
ETHERNET CABLE
ETHERNET CABLE
ETHERNET
CABLE
CAMERA CABLE
15