Check Your Programming - White Rodgers 1F80-0224 Installation And Operating Instructions Manual

PROGRAMMING
7. Repeat steps 3 through 5 for the 3rd and 4th heating
program periods.
8. When you have completed entering your heating program,
press RUN/HOLD.
CAUTION
!
If the outside temperature is below 50
power to the cooling system before programming.
Energizing the air conditioner compressor during
cold weather may cause personal injury or property
damage.
Enter Cooling Program
1. Move SYSTEM switch to COOL position.
2. Follow Enter Heating Program for entering your
cooling program, using your selected cooling times and
temperatures.
Follow these steps to check your thermostat programming one
fi nal time before beginning thermostat operation.
1. Move SYSTEM switch to HEAT position.
2. Press PRGM to view the 1st weekday heating period time
and temperature. Each time you press PRGM, the next
heating period time and temperature will be displayed in
o
F, disconnect
sequence for weekday, then Saturday and Sunday program
periods (you may change any time or temperature during
this procedure).
3. Press RUN/HOLD.
4. Move SYSTEM switch to COOL position.
5. Repeat step 2 to check cooling program.
6. Move SYSTEM switch to HEAT or COOL and press RUN/
HOLD to begin program operation.
YOUR THERMOSTAT IS NOW PROGRAMMED AND READY TO
PROVIDE MAXIMUM COMFORT AND EFFICIENCY!
8

CHECK YOUR PROGRAMMING