Program The Water Softener; Set Time Of Day - Whirlpool WHES40 Installation And Operation Manual

Program the Water Softener
SET SALT LEVEL button Display
TANK LIGHT button
UP button
/
RECHARGE button
GRAM
TRESS TO SCHEDULE
HOLD TO START
_ECHARGE
/ \
PROGRAM button DOWN Button
J
Figure 10
If you have questions about installation, programming, operating and routine maintenance...
call 1-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.
Set Time of Day
When the water softener is plugged in, a model code and a test number (example: J1.0), begin to flash
) " •
in the faceplate display. Then, "12:00 PM" and the ",w rds CURRENT TIME" begin to flash.
NOTE: If .... shows in the display, press the UP _ or DOWN _ until LE40 shows
in the display. Then, press the O PROGRAM button to set, and change to the
flashing "CURRENT TIME" display.
If the words "CURRENT TIME" do not show in the display, press the O PROGRAM button until
they do.
1. Press the _ Up or _ Down buttons to set the present time. Up sets the display ahead; down
sets the time back.
U'£O,.
l.gO
C_nt
Time
# m.3c
I /.gO
C_nt
Time
Be sure AM or PM is correct.
NOTE: Press buttons and quickly release to slowly advance the display. Hold the buttons
down for fast advance. This procedure applies for all following settings.
16