Avaya J100 Series Installing And Administering page 462

Customizable parameters
Parameter name
STUN_SERVER_ADDRESS
STUN_UDP_INITIAL_TIMEOUT_MSEC
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Default value
Null
500
environment
Description
This is the basic STUN
parameter defining the
STUN server address.
Other parameters listed
below will be ignored if this
parameter is not set.
The valid value is an IPv4
address in the dotted
decimal format or a
FQDN.
Note:
If specified as an IPv4 address, the
STUN server port will default to
3478. It is applicable only when
3PCC_SERVER_MODE=0 or
3PCC_SERVER_MODE=2 and
ENABLE_3PCC_ENVIRONMENT=1
The following characters
are allowed:
• 0 – 9
• a – z
• A – Z
• dot (".")
For example, SET
STUN_SERVER_ADDRESS
192.168.161.54
Determines the initial
timeout, in milliseconds, to
wait for a Response to a
STUN Request sent over
UDP. The timeout value is
internally doubled after
each (re)transmission.
Valid values are positive
integers from 500 (0,5
sec) to 3000 (3 sec).
Table continues...
462